Grass Valley iControlEdge v.1.20 Installation - Manual (Page 80)

76
Installation & Setup 33
Key Description
blinkWhenUnacknowledged Default value is “NO.” Setting this value to “YES” causes new Alarms to blink in
the monitoring application page. Operator has to acknowledge individual
alarms to stop the blinking. If ackAudibleAlarm is enabled, the operator can
click the Acknowledge button to acknowledge all alarms at once.
ackAudibleAlarm Default “YES” value causes an audible alarm (chime) to activate when a new
alarm comes in, and allows operators to temporarily mute the chime, by
clicking the Acknowledge button. When another alarm comes in, the audible
alarm will be re-activated. Click the Mute sound button to mute the audible
alarm and prevent it from being re-activated automatically (until you decide
otherwise by clicking Unmute sound). Set ackAudibleAlarm to “NO” to disable
the audible alarm, and hide both the Acknowledge and Mute/unmute sound
buttons.
alternateGroupLabel The Channel Selector can be sorted on the basis of
some criteria, including logical groups defined in the
Services worksheet and referred to as Logical group in
the context of the Channel Selector’s sort menu. The
alternate label you can provide here will appear in the
Channel Selector’s sort menu to designate an
additional set of groups, also defined in the Services
worksheet (see “Services Worksheet” on page 70).
The default value is “TS” (i.e. “transport stream”).
EMBEDDED WEB PAGES In the Embedded Web Pages section, you can define and configure up to two
custom Application Selector buttons linked to Web pages or iC Web pages. To
configure a button, remove the asterisks at the beginning of the corresponding
rows (the set of four rows that start with either “browserButton0” or
“browserButton1”), and type the desired values for the four parameters (the
parameters for the first button are described below; the other button is
configured in the same fashion).
Note: A custom button is added to the application Selector, only if the
associated URL or MPF file path is specified.
browserButton0_url The address of a Web page (URL) or iC Web page (path to MPF file, relative to
EDGE/Web_pages). Default value is “http://www.miranda.com”.