Grass Valley iControlEdge v.1.20 Installation - Manual (Page 41)

Enabling Audio Level Meters
37
Example of a control panel showing Thumbnail settings
Enabling Audio Level Meters
The procedure below is an example showing how to enable the appropriate audio level meter on HCP-1801
cards. Some steps may vary, depending on your actual card model. Refer to the documentation that
shipped with the card you wish to configure (see “Reference Material” on page 6).
To enable audio level meters:
1. In iControl Navigator, select the Densité card you wish to configure.
2. On the View menu, click Show control panel, to open the card’s control panel.
3. Click the control panel’s RALM tab.
4. Under RALM remote control, select the AES1 check box.
5. Select Fast from the Speed list.