Grass Valley iControlEdge v.1.20 Installation - Manual (Page 21)

Preparing to Install an iControl Edge System
17
One ADC-800 CAM HDV camera HD/SD A to D converter, for each HCP-1801 module you ordered
Blank rear panels (for empty slots)
One AC power supply unit and AC cord
A second power supply and AC cord (optional)
Make sure the following items have been shipped with your Allégro systems:
Allégro unit (Dell PowerEdge 850, 860, or R200 server)
Rack mounting kit (rails, screws and washers)
AC power cord
Once the hardware components are all in place, each device must be configured to work on a common TCP/
IP network. Other operational parameters, such as which alarm conditions are to be monitored, should also
be configured.
You will need a PC or laptop that can connect to certain iControl Edge devices using a crossover Ethernet
cable or via a network switch. The PC or laptop will need to have its network settings temporarily changed
to ones that are compatible with the device.
Video probes Audio probes
VCP-1021 Composite Video Control Probe ACP-1721 Digital Audio Control Probe
...or any of the following: ...with any of the following
DEC-1002 10-Bit Composite to SDI Decoder UAP-1781 Eight-Channel Universal Audio
Processor
DEC-1003 10-Bit Composite to SDI Decoder UAP-1783 Eight-Channel Universal Audio
Processor
DEC-1021 12-Bit Composite to SDI Decoder AAP-1741 Four-Channel Analog Audio Processor
DEC-1023 12-Bit Composite to SDI Decoder
...or the following probe: ...with the following converter:
HCP-1801HD/SD SDI Control Probe ADC-800 CAM
HDV Camera HD/SD A-to-D Converter
Note: Densité devices ship with some pre-configured alarm settings that must be changed for
proper operation of your iControl Edge system. See “Configuring the Probing Features” on
page 36. Before making any such changes, please refer to the documentation specific to each
device (see “Reference Material” on page 6).