Grass Valley iControlEdge v.1.20 Installation - Manual (Page 35)

Restarting the System and Verifying the Configuration
31
Restarting the System and Verifying the Configuration
Once you have specified all the settings your Application Server needs to be able to operate on your local
network, you must restart the system to apply the new configuration.
Make sure you fulfill the following conditions before beginning this procedure:
• You are logged on to iControl Webmin (see “Logging on to Webmin” on page 22).
• You have performed step 2 through step 4 of “Configuring the Network” on page 23.
To restart the system and verify the configuration:
1. On the Webmin home page, click Bootup and Shutdown:
The Bootup and Shutdown page appears.
2. At the bottom of the Bootup and Shutdown page, click Reboot System:
Notes
•
Clicking Save does not update the Application Server with the new configuration. To apply
your changes, you still need to click Apply Configuration on the Network Configuration page
or restart the system through Webmin (see “Restarting the System and Verifying the
Configuration” on page 31).
• The Application Server’s eth0 port is set to auto-negotiate, full duplex mode by default. This
setting should not be changed. The network switch to which the Application Server is
connected should also be set to auto-negotiate to avoid data packet loss.