Grass Valley iControlEdge v.1.20 Installation - Manual (Page 54)

50
Installation & Setup 33
18. Type the new IP address, network mask, and default gateway address in the corresponding boxes, and
then click Apply.
Configuring Allégro Streaming Relays
In an iControl Edge configuration, operators typically monitor audio/video streams from several remote
locations at once. Having each remote Allégro send a stream to multiple operators over a WAN can result in
performance problems. The recommended alternative is to have each remote Allégro send its stream to the
Application Server, and then have these streams relayed over the local network to the operators’ client
workstations.
To configure streaming relays:
On the Application Server, for each Allégro in the configuration, you will need to create a file that provides
some important parameters.
1. Launch WinSCP. If you do not have WinSCP installed on your PC or laptop, see “Using WinSCP” on
page 97.
2. Log on to the Application Server (see “Logging on to an Application Server from WinSCP” on page 103).
Note: Only user root is allowed to add or modify files in the specific directory where the
streaming relay configuration files must be located. Be sure to log on as user root (default
password is icontrol).