Grass Valley iControlEdge v.1.20 Installation - Manual (Page 45)

Installing & Configuring GC-100 Network Adapters
41
The Profile copy for card window appears, with the current card identified under Copy profile from.
All other cards of the same type are listed under Copy profile to.
12. For each card to which you wish to copy the current profile, select the corresponding check box in the
Select column.
13. Select Select All at the top of the column to select all the available cards.
14. Click Copy.
A successful copy is indicated for each card by the appearance of the word “Succeeded” in the Transfer
Status column.
15. Click Exit to close the Profile Copy for Card window.
16. Close the iControl Navigator window.
This will also close any control panels that were left open, and other secondary windows.
Step 4: Installing & Configuring GC-100 Network Adapters
Install and configure your GC-100 units to make them available on your local network. You also need to
configure the appropriate number of IR or Sensor connectors on each unit as IR output. Refer to the Global
Caché GC-100-12 Network Adapter Quick Start Guide (see “Reference Material” on page 6) for details.
Configuring the GC-100 IR Service
Once your GC-100 units are connected to your local network you must enable the GC-100 IR service on the
Application Server.
To enable the GC-100 Service:
1. Log on to Webmin (see “Logging on to Webmin” on page 22).
2. Click Miranda iControl Management Tool.
The Miranda Setup page appears.
3. Click the iControl logo next to iControl services monitoring and configuration tool.
The Miranda Monitoring page appears.
4. Find the row corresponding to the GC-100 IR service.
Note: The copy profile operation is prohibited when a target card does not have the same
firmware version as the source card. In such cases, the designation “N/A” will appear on a yellow
background in the Transfer status column.