Grass Valley iControlEdge v.1.20 Installation - Manual (Page 34)

30
Installation & Setup 33
3. Click Static, and then type the fixed IP address you would like to use for this Application Server:
4. Type addresses in the Netmask and Broadcast boxes that correspond to your desired network
configuration.
The values you type should be based on the IP address and the desired network configuration. In the
above example (10.10.80.10), the corresponding netmask has been configured as 255.255.255.0, with
a resulting broadcast address of 10.10.80.255. You should always verify these values with your network
administrator.
5. Leave the MTU box blank.
6. Click the Yes option button, next to Activate at boot.
7. Click Save.
Note: This page shows the current settings for the eth0 interface, which are the factory default
values if you are configuring this port for the first time.
Notes
•
Make sure you type the IP address exactly as it is on the Edit Host Address page (see step 3 of
“Configuring Host Addresses” on page 26).
• Typically the IP addresses for all devices on a LAN will begin with the same two data groups,
and the remaining two will be assigned by the system administrator.
Note: If you do not click Yes, the eth0 interface will return to its previous configuration the next
time the system restarts.