Grass Valley iControlEdge v.1.20 Installation - Manual (Page 74)

70
Installation & Setup 33
2. For each Path, specify a unique ID, and the TYPE of set-top box being used in the path (STB-CYCLING
or STB-MANUAL). Specify the associated set-top box ID.
• For a cycling path, specify the virtual device IDs representing the associated pair of video and audio
probes.
• For a manual path, specify the card IDs representing the associated pair of video and audio probes, if
present.
Services Worksheet
To define the services at this location:
1. Click the Services tab.
The Services worksheet is used to define the services or channels assigned to a path:
Services worksheet (part 1, description and configuration of the Channel Selector area)
ENABLE Type “YES” to enable a Path, “NO” to disable it for troubleshooting or
maintenance.
STB ID Unique ID of a set-top box (or DVR), as specified on the Devices worksheet. Case
sensitive. Mandatory.
VIDEO ID Unique ID of a video probe, as specified on the Devices worksheet. Case sensitive.
Mandatory in cycling paths. Optional in manual paths.
AUDIO ID Unique ID of an audio probe, as specified on the Devices worksheet. Case
sensitive. Mandatory in cycling paths. Optional in manual paths.
ALLEGRO ID Unique ID of the Allégro, as specified on the Devices worksheet. Case sensitive.
Mandatory.
Note: In the case of HCP-1801 HD/SD video control probes with embedded audio, both VIDEO
ID and AUDIO ID should refer to the same virtual device ID (in cycling paths) or card ID (in manual
paths).
Column Description