Grass Valley iControlEdge v.1.20 Installation - Manual (Page 36)

32
Installation & Setup 33
The Application Server restarts with the network parameters you have established.
3. Verify that the Application Server is connected to your local LAN via an Ethernet cable plugged into the
eth0 port.
4. Restore the previous network settings on the PC or laptop that was used to configure the Application
Server (see “Configuring a Client PC or Laptop” on page 18).
5. Verify that the Application Server is available on your network. From a workstation on the same subnet,
open a browser window and type the IP address of the newly-configured Application Server. You
should see the iControl Startup page.
6. Alternatively, you can use the ping command. Open the DOS command line window on the client PC or
laptop (on the Start menu, click Run), and then type the following:
ping AAA.BBB.CCC.DDD
where AAA.BBB.CCC.DDD is the Application Server’s new IP address. A small window should briefly
appear with a message similar to the following:
Reply from AAA.BBB.CCC.DDD: bytes=32 time<1ms TTL=62
Note: If this is a workstation that will be used to operate iControl Edge, make sure that the Java
Runtime Environment is installed (refer to “Installing Java” on page 21).