Grass Valley iControlEdge v.1.20 Installation - Manual (Page 30)

26
Installation & Setup 33
6. Return to the Network Configuration page by clicking the Return arrow at the bottom of the Hostname
and DNS Client page.
Configuring Host Addresses
Before beginning this procedure, make sure you have navigated to the Network Configuration page of
Webmin (see “Navigating to the Network Configuration Page” on page 24).
To configure host addresses:
1. On the Network Configuration page, click Host Addresses.
The Host Addresses page appears. The currently defined hosts are listed, showing the IP address and
host name of each:
2. Click the IP address of the Application Server (10.0.3.6 in the example screen shown above).
The Edit Host Address page appears:
Note: Clicking Save does not update the Application Server with the new configuration. To
apply your changes, you still need to click Apply Configuration on the Network Configuration
page or restart the system through Webmin (see “Restarting the System and Verifying the
Configuration” on page 31).
Note: Do not click Apply Configuration on the Network Configuration page.
Notes
•
The first entry (IP Address: 127.0.0.1, Hostname: localhost.localdomain, localhost) is
predefined and should be left as found.
• The host name you defined in step 2 of “Specifying DNS Client Settings” on page 24 should be
listed here. However, you will need to assign an appropriate IP address to this Application
Server.