Grass Valley iControlEdge v.1.20 Installation - Manual (Page 48)

44
Installation & Setup 33
Configuring Allégro systems
Before you can begin operations, you must configure each Allégro and make it available on your local
network. Specifically, you may have to:
• access the Allégro
• configure network and other settings
• set up streaming relays
• apply your changes and perform a readiness check
Accessing the Allégro
The Allégro has a built-in Web-based management utility. This utility is available as soon as the system is
powered up, and can be used to configure the system using a Web browser on any PC or laptop, provided
the PC or laptop can reach the Allégro’s IP address.
To access the Allégro system:
1. Configure your Client PC or laptop with an IP address in the same range as the IP address of the Allégro.
See “Configuring a Client PC or Laptop” on page 18.
2. Open a Web browser and type the Allégro’s default IP address (see “Network Configuration” on
page 11), specifying a connection on port 8080:
http://10.3.0.7:8080/
The Allégro Startup Page appears: