Grass Valley iControlEdge v.1.20 Installation - Manual (Page 23)

Installing & Configuring the Application Server
19
page 11, for the default addresses of the Application Servers, Densité frames, GC-100 network adapter,
and Allégro systems).
6. Type a subnet mask in the same range as that of the targeted device.
7. Click OK to apply these settings.
8. Click OK again, to close the Local Area Connection Properties window.
9. Close the Network Connections control panel.
Step 2: Installing & Configuring the Application Server
Miranda’s iControl Application Server is the hardware at the heart of the iControl Edge system, providing
control, monitoring, logging and interface services. The Application Server is a compact 1RU server that
interfaces to other devices over TCP/IP. A user can connect to the Application Server via TCP/IP from any
convenient desktop or portable computer.
Physically Installing the Application Server
To install the Application Server:
1. Place the Application Server in a standard 19-inch rack, using the rails, screws and washers provided.
Make sure that the unit has adequate ventilation.
2. To configure and operate the Application Server, you must be able to access it from a client PC or laptop
over an Ethernet connection. Use the eth0 port on the rear panel of the Application Server.
Note: Remember to return the PC to its original network settings once you have finished
configuring the devices.