H3C Technologies H3C SecBlade LB Cards - Manual (Page 90)

79
a. Log in to IMC, click the Service tab, and select User Access Manager > Access Device
Management > Access Device from the navigation tree.
b. Click Add to configure an access device as follows:
Set the shared key for secure authentication and accounting communication to expert.
Set the ports for authentication and accounting to 1812 and 1813, respectively.
Select the service type Device Management Service.
Select the access device type H3C(General).
Select the access device from the device list or manually add the access device (with the IP
address 10.1.1.2).
c. Click OK.
The IP address of the access device specified here must be the same as the source IP address of the
RADIUS packets sent from the device, which is chosen in the following order:
{
IP address specified with the nas-ip command on the device.
{
IP address specified with the radius nas-ip command on the device.
{
IP address of the outbound interface (the default).
Figure 30 Adding LB as an access device
2. Add a user account for device management:
a. Click the User tab, and then select Access User View > Device Mgmt User from the navigation
tree.
b. Click Add to configure a device management account as follows:
Enter the account name hello@bbb and specify the password.
Select the service type Telnet.
Set the EXEC privilege level to 3. This argument identifies the privilege level of the Telnet user
after login and defaults to 0.
Specify 10.1.1.0 to 10.1.1.255 as the IP address range of the hosts to be managed. The IP
address range must contain the IP address of the access device.
c. Click OK.