H3C Technologies H3C SecBlade LB Cards - Manual (Page 175)

164
Step Command Remarks
5. Set the maximum number of
SSH authentication attempts. ssh server authentication-retries
times
Optional.
3 by default.
Authentication fails if the number of
authentication attempts (including
both publickey and password
authentication) exceeds the upper
limit.
6. Configure the SFTP
connection idle timeout
period.
sftp server idle-timeout
time-out-value Optional.
10 minutes by default.
Configuring the device as an Stelnet client
This section describes how to configure the device as an Stelnet client.
Stelnet client configuration task list
Task Remarks
Specifying a source IP address or source interface for the Stelnet client Optional.
Enabling and disabling first-time authentication Optional.
Establishing a connection to an Stelnet server Required.
Specifying a source IP address or source interface for the
Stelnet client
By default, an Stelnet client uses the IP address of the outbound interface specified by the route to the
Stelnet server as the source IP address to communicate with the Stelnet server. You can change the source
IP address or specify a source interface for the client.
To make sure the Stelnet client and the Stelnet server can communicate with each other, and to improve
the manageability of Stelnet clients in the authentication service, H3C recommends that you specify a
loopback interface as the source interface.
To specify a source IP address or source interface for the Stelnet client:
Step Command Remarks
1. Enter system view. system-view N/A