H3C Technologies H3C SecBlade LB Cards - Manual (Page 19)

8
Figure 4 Modifying a security zone
3. Modify the zone as described in Table 2 .
4. Click Apply.
Table 2 Configuration items
Item Description
Zone ID Display the zone ID.
Zone Name Display the zone name.
Preference
Set the preference of the specified security zone.
By default, packets from a high priority security zone to a low priority security zone
are allowed to pass.
Share Set whether the specified security zone can be referenced by other VDs.
Virtual Device Display the VD to which the security zone belongs.
Interface
Interface
Set the interfaces to be added to the security zone.
The interfaces that have been added to a security zone are in the selected status,
and the interfaces that can be added but have not been added to a security zone
are in the non-selected status.
VLAN
If the interfaces added to the security zone are Layer 2 Ethernet interfaces, you
must specify the range of the VLANs to be added to the security zone. The VLANs
must belong to the VD to which the security zone belongs and have not been
added to other security zones.