H3C Technologies H3C SecBlade LB Cards - Manual (Page 106)

95
Step Command Remarks
4. Configure the minimum
password length for the local
user.
password-control length length
Optional.
By default, the setting equals that
for the user group to which the
local user belongs. If no minimum
password length is configured for
the user group, the global setting
applies to the local user.
5. Configure the password
composition policy for the
local user.
password-control composition
type-number type-number
[ type-length type-length ]
Optional.
By default, the settings equal those
for the user group to which the
local user belongs. If no password
composition policy is configured
for the user group, the global
settings apply to the local user.
Setting super password control parameters
CLI commands fall into four levels: visit, monitor, system, and manage, in ascending order. Accordingly,
login users fall into four levels, each corresponding to a command level. A user of a certain level can only
use the commands at that level or lower levels.
To switch from a lower user level to a higher one, a user needs to enter a password for authentication.
This password is called a super password. For more information on super passwords, see System
Management Configuration Guide.
To set super password control parameters:
Step Command Remarks
1. Enter system view. system-view N/A
2. Set the password aging time
for super passwords. password-control super aging
aging-time
Optional.
By default, the super password
aging time is the same as the
global password aging time.
3. Configure the minimum length
for super passwords. password-control super length
length
Optional.
By default, the minimum super
password length is the same as the
global minimum password length.
4. Configure the password
composition policy for super
passwords.
password-control super
composition type-number
type-number [ type-length
type-length ]
Optional.
By default, the super password
composition policy is the same as
the global password composition
policy.