H3C Technologies H3C SecBlade LB Cards - Manual (Page 77)

66
Task Remarks
Specifying the HWTACACS authentication servers Required
Specifying the HWTACACS authorization servers Optional
Specifying the HWTACACS accounting servers and the relevant parameters Optional
Specifying the shared keys for secure HWTACACS communication Required
Specifying a VPN for the HWTACACS scheme Optional
Setting the username format and traffic statistics units Optional
Specifying the source IP address for outgoing HWTACACS packets Optional
Setting HWTACACS timers Optional
Displaying and maintaining HWTACACS Optional
Creating an HWTACACS scheme
The HWTACACS protocol is configured on a per scheme basis. Before you perform other HWTACACS
configurations, create an HWTACACS scheme and enter HWTACACS scheme view. You can configure
up to 16 HWTACACS schemes.
To create an HWTACACS scheme and enter HWTACACS scheme view:
Step Command Remarks
1. Enter system view. system-view N/A
2. Create an HWTACACS scheme and
enter HWTACACS scheme view.
hwtacacs scheme
hwtacacs-scheme-name
Not defined by default.
You can delete an HWTACACS scheme only when it is not referenced.
Specifying the HWTACACS authentication servers
You can specify one primary authentication server and one secondary authentication server for an
HWTACACS scheme. When the primary server is not available, the secondary server is used. If no
redundancy is needed, specify only the primary server.
An HWTACACS server can function as the primary authentication server of one scheme and as the
secondary authentication server of another scheme at the same time. You cannot specify the same IP
address as both the primary and the secondary authentication servers in a scheme.
To specify HWTACACS authentication servers for an HWTACACS scheme:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter HWTACACS
scheme view.
hwtacacs scheme hwtacacs-scheme-name N/A