H3C Technologies H3C SecBlade LB Cards - Manual (Page 42)

31
Step Command Remarks
1. Enter system view. system-view N/A
2. Create an IPv6
advanced ACL
and enter its view.
acl ipv6 number acl6-number [ name
acl6-name ] [ match-order { auto |
config } ]
By default, no ACL exists.
IPv6 advanced ACLs are numbered in the
range of 3000 to 3999.
You can use the acl ipv6 name acl6-name
command to enter the view of a named
ACL.
3. Configure a
description for the
IPv6 advanced
ACL.
description text
Optional.
By default, an IPv6 advanced ACL has no
ACL description.
4. Set the rule
numbering step.
step step-value
Optional.
The default setting is 5.
5. Create or edit a
rule.
rule [ rule-id ] { deny | permit } protocol
[ { { ack ack-value | fin fin-value | psh
psh-value | rst rst-value | syn syn-value
| urg urg-value } * | established } |
counting | destination { dest-address
dest-prefix | dest-address/dest-prefix |
any } | destination-port operator port1
[ port2 ] | dscp dscp | flow-label
flow-label-value | fragment |
icmp6-type { icmp6-type icmp6-code |
icmp6-message } | logging | routing
[ type routing-type ] | source
{ source-address source-prefix |
source-address/source-prefix | any } |
source-port operator port1 [ port2 ] |
time-range time-range-name |
vpn-instance vpn-instance-name ] *
By default IPv6 advanced ACL does not
contain any rule.
The logging keyword takes effect only
when the module using the ACL supports
logging.
The device does not support the counting
keyword.
6. Add or edit a rule
comment.
rule rule-id comment text
Optional.
By default, no rule comments are
configured.
7. Add or edit a rule
range remark.
rule [ rule-id ] remark text
Optional.
By default, no rule range remarks are
configured.
Configuring an Ethernet frame header ACL
Ethernet frame header ACLs, also called "Layer 2 ACLs," match packets based on Layer 2 protocol
header fields, such as source MAC address, destination MAC address, 802.1p priority (VLAN priority),
and link layer protocol type.
To configure an Ethernet frame header ACL:
Step Command Remarks
1. Enter system view. system-view N/A