beautypg.com

Layer 3 static aggregation configuration example, Network requirements, Configuration procedure – H3C Technologies H3C S5560 Series Switches User Manual

Page 87: Verifying the configuration

background image

53

GE1/0/1 0 32768 0 0x8000, 0000-0000-0000 {DEF}

GE1/0/2 0 32768 0 0x8000, 0000-0000-0000 {DEF}

The output shows that GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 are in Individual state when
they do not receive LACPDUs from the server. Both GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2

can forward traffic. When one port fails, its traffic is automatically switched to the other port.

Layer 3 static aggregation configuration example

Network requirements

On the network shown in

Figure 16

, perform the following tasks:

Configure a Layer 3 static aggregation group on both Device A and Device B.

Configure IP addresses and subnet masks for the corresponding Layer 3 aggregate interfaces.

Figure 16 Network diagram

Configuration procedure

1.

Configure Device A:
# Create Layer 3 aggregate interface Route-Aggregation 1, and configure an IP address and
subnet mask for the aggregate interface.

system-view

[DeviceA] interface route-aggregation 1

[DeviceA-Route-Aggregation1] ip address 192.168.1.1 24

[DeviceA-Route-Aggregation1] quit

# Assign Layer 3 Ethernet interfaces GigabitEthernet 1/0/1 through GigabitEthernet 1/0/3 to
aggregation group 1.

[DeviceA] interface gigabitethernet 1/0/1

[DeviceA-GigabitEthernet1/0/1] port link-aggregation group 1

[DeviceA-GigabitEthernet1/0/1] quit

[DeviceA] interface gigabitethernet 1/0/2

[DeviceA-GigabitEthernet1/0/2] port link-aggregation group 1

[DeviceA-GigabitEthernet1/0/2] quit

[DeviceA] interface gigabitethernet 1/0/3

[DeviceA-GigabitEthernet1/0/3] port link-aggregation group 1

[DeviceA-GigabitEthernet1/0/3] quit

2.

Configure Device B in the same way Device A is configured. (Details not shown.)

Verifying the configuration

# Display detailed information about all aggregation groups on Device A.

[DeviceA] display link-aggregation verbose

Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing

Port Status: S -- Selected, U -- Unselected, I -- Individual

Flags: A -- LACP_Activity, B -- LACP_Timeout, C -- Aggregation,