H3C Technologies H3C S5560 Series Switches - Manual (Page 310)

276
VLAN mapping configuration (1\1), 218 , 225
VLAN mapping configuration (1\2), 223 , 230
VLAN mapping configuration (2\2), 224 , 230
VLAN mapping configuration (M\1), 219 , 225
VLAN mapping configuration (M\1) (dynamic
IP address assignment),
219
VLAN mapping configuration (M\1) (static IP
address assignment),
221
parameter
spanning tree timeout factor, 84
per-flow load sharing, 29 , 43
performing
interface loopback test (Ethernet), 6
spanning tree mCheck, 93
per-packet load sharing, 29
Per-VLAN Spanning Tree Protocol. Use PVST
PFC (Ethernet interface), 8
physical
interface physical state change suppression
(Ethernet), 5
polling
interface statistics polling interval (Ethernet), 10
LAN switching LLDP enable, 242
port
Ethernet aggregate interface, 36
Ethernet aggregate interface (description), 36
Ethernet link aggregate group Selected ports
min/max, 38
Ethernet link aggregate interface (expected
bandwidth), 39
Ethernet link aggregate interface default
settings, 41
Ethernet link aggregate interface shutdown, 40
Ethernet link aggregation
configuration, 22 , 29 , 45
Ethernet link aggregation configuration
types, 23
Ethernet link aggregation dynamic mode, 26
Ethernet link aggregation edge aggregate
interface, 29 , 40
Ethernet link aggregation group, 30
Ethernet link aggregation group (dynamic), 32
Ethernet link aggregation group (static), 31
Ethernet link aggregation LACP, 26
Ethernet link aggregation LACP port priority, 26
Ethernet link aggregation load sharing, 41
Ethernet link aggregation load sharing mode, 29
Ethernet link aggregation local-first load
sharing, 42
Ethernet link aggregation member port, 22
Ethernet link aggregation member port
state, 23 , 25 , 27
Ethernet link aggregation modes, 24
Ethernet link aggregation operational key, 23
Ethernet link aggregation per-flow load sharing
algorithm settings, 43
Ethernet link aggregation reference port, 27
Ethernet link aggregation reference port choice, 24
Ethernet link aggregation static mode, 24
Ethernet link aggregation traffic redirection, 44
interface fiber port (Layer 2 Ethernet), 13
isolation. See port isolation
LAN switching LLDP basic configuration, 240 , 250
LAN switching LLDP configuration, 233 , 240 , 250
LAN switching LLDP disable operating mode, 238
LAN switching LLDP enable, 240
LAN switching LLDP frame encapsulation
format, 247
LAN switching LLDP frame reception, 239
LAN switching LLDP frame transmission, 239
LAN switching LLDP operating mode, 242
LAN switching LLDP polling, 242
LAN switching LLDP reinitialization delay, 242
LAN switching LLDP Rx operating mode, 238
LAN switching LLDP Tx operating mode, 238
LAN switching LLDP TxRx operating mode, 238
Layer 2 aggregate interface (ignored VLAN), 37
Layer 2 Ethernet link aggregation (dynamic), 47
Layer 2 Ethernet link aggregation (static), 45
Layer 2 Ethernet link aggregation edge aggregate
interface, 51
Layer 2 Ethernet link aggregation group
(dynamic), 32
Layer 2 Ethernet link aggregation group (static), 31
Layer 2 Ethernet link aggregation load sharing, 49
Layer 3 aggregate interface configuration
(MTU),
37
Layer 3 Ethernet link aggregation (dynamic), 54
Layer 3 Ethernet link aggregation (static), 53
Layer 3 Ethernet link aggregation edge aggregate
interface,
55