H3C Technologies H3C S5560 Series Switches - Manual (Page 239)

205
Protocol type Value
IS-IS 0x8000
LACP 0x8809
802.1X 0x888E
LLDP 0x88CC
802.1ag 0x8902
Cluster 0x88A7
Reserved 0xFFFD/0xFFFE/0xFFFF
Configuring the CVLAN TPID
Step Command Remarks
1. Enter system view. system-view N/A
2. Configure the TPID value for
CVLAN tags. qinq ethernet-type customer-tag
hex-value
The default setting is 0x8100 for
CVLAN tags.
Configuring the SVLAN TPID
When you configure the SVLAN ID, follow these restrictions and guidelines:
• Configure the SVLAN TPID on service provider-side ports of PEs.
• Do not configure the SVLAN TPID on a QinQ-enabled port.
To configure the SVLAN TPID:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter Ethernet interface view
or aggregate interface view. interface interface-type
interface-number
N/A
3. Configure the SVLAN TPID.
qinq ethernet-type service-tag
hex-value The default setting is 0x8100 for
SVLAN tags.
Setting the 802.1p priority in SVLAN tags
By default, a QinQ-enabled port sets the 802.1p priority in the SVLAN tag depending on the priority trust
mode.
• If the 802.1p priority is trusted, the port copies the 802.1p priority in the CVLAN tag to the SVLAN
tag.
• If port priority is trusted, the port sets the 802.1p priority in the SVLAN to be the same as the port
priority. The default port priority is 0.
Alternatively, you can configure a QoS policy to set the 802.1p priority in the SVLAN by using one of the
following methods: