Configuring a layer 3 static aggregation group, Configuring a dynamic aggregation group, Configuring a layer 2 dynamic aggregation group – H3C Technologies H3C S5560 Series Switches User Manual
Page 66
32
Configuring a Layer 3 static aggregation group
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Create a
Layer 3
aggregat
e
interface
and enter
Layer 3
aggregat
e
interface
view.
interface route-aggregation
interface-number
When you create a Layer 3
aggregate interface, the system
automatically creates a Layer 3
static aggregation group
numbered the same.
3.
Exit to
system
view.
quit
N/A
4.
Assign
an
interface
to the
specified
Layer 3
aggregat
ion
group.
a.
Enter Layer 3 Ethernet
interface view:
interface interface-type
interface-number
b.
Assign
the
interface
to the
specified
Layer 3
aggregat
ion
group:
port
link-aggr
egation
group
number
Repeat these two sub-steps to
assign more Layer 3 Ethernet
interfaces to the aggregation
group.
Configuring a dynamic aggregation group
To guarantee a successful dynamic aggregation, make sure that the peer ports of the ports aggregated
at one end are also aggregated. The two ends can automatically negotiate the aggregation state of each
member port.
Configuring a Layer 2 dynamic aggregation group
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
- H3C S5130 Series Switches H3C S5120 Series Switches H3C SR8800 H3C SR6600-X H3C SR6600 H3C MSR 5600 H3C MSR 50 H3C MSR 3600 H3C MSR 30 H3C MSR 2600 H3C MSR 20-2X[40] H3C MSR 20-1X H3C MSR 930 H3C MSR 900 H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSWM1WCM10 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module