Displaying and maintaining qinq, Qinq configuration examples, Basic qinq configuration example – H3C Technologies H3C S5560 Series Switches User Manual
Page 241: Network requirements
207
Step Command
Remarks
14.
Apply the QoS policy to the
inbound direction of the
port.
qos apply policy policy-name inbound
N/A
For more information about QoS policies, see ACL and QoS Configuration Guide.
Displaying and maintaining QinQ
Execute display commands in any view.
Task
Command
Display QinQ-enabled ports.
display qinq [ interface interface-type
interface-number ]
QinQ configuration examples
Basic QinQ configuration example
Network requirements
As shown in
:
•
The service provider assigns VLAN 100 to Company A's VLANs 10 through 70.
•
The service provider assigns VLAN 200 to Company B's VLANs 30 through 90.
•
The devices between PE 1 and PE 2 in the service provider network use a TPID value of 0x8200.
Configure QinQ on PE 1 and PE 2 to transmit traffic in VLANs 100 and 200 for Company A and
Company B, respectively.
For the QinQ frames to be identified correctly, set the SVLAN TPID to 0x8200 on the service provider-side
ports of PE 1 and PE 2.
- H3C S5130 Series Switches H3C S5120 Series Switches H3C SR8800 H3C SR6600-X H3C SR6600 H3C MSR 5600 H3C MSR 50 H3C MSR 3600 H3C MSR 30 H3C MSR 2600 H3C MSR 20-2X[40] H3C MSR 20-1X H3C MSR 930 H3C MSR 900 H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSWM1WCM10 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module