H3C Technologies H3C S5560 Series Switches User Manual
Page 62
28
Figure 10 Setting the state of a member port in a dynamic aggregation group
The system with the higher system ID is aware of the aggregation state changes on the remote system. The
system sets the aggregation state of local member ports the same as their peer ports.
When you aggregate interfaces in dynamic mode, follow these guidelines:
•
A dynamic link aggregation group preferably chooses full-duplex ports as the Selected ports. The
group chooses only one half-duplex port as a Selected port when either of the following conditions
exist:
{
None of the full-duplex ports can become Selected ports.
{
Only half-duplex ports exist in the group.
•
To ensure stable aggregation and service continuity, do not change the operational key or attribute
configurations on any member port.
•
When the aggregation state of a local port changes in a dynamic aggregation group, the
aggregation state of the peer port also changes.
- H3C S5130 Series Switches H3C S5120 Series Switches H3C SR8800 H3C SR6600-X H3C SR6600 H3C MSR 5600 H3C MSR 50 H3C MSR 3600 H3C MSR 30 H3C MSR 2600 H3C MSR 20-2X[40] H3C MSR 20-1X H3C MSR 930 H3C MSR 900 H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSWM1WCM10 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module