H3C Technologies H3C S5560 Series Switches - Manual (Page 281)

247
Step Command Remarks
1. Enter system view. system-view N/A
2. Set the TTL multiplier. lldp hold-multiplier value The default setting is 4.
3. Set the LLDP frame
transmission interval.
lldp timer tx-interval interval
The default setting is 30
seconds.
4. Set the token bucket size for
sending LLDP frames.
lldp max-credit credit-value The default setting is 5.
5. Set the number of LLDP frames
sent each time fast LLDP frame
transmission is triggered.
lldp fast-count count The default setting is 4.
6. Set the interval for fast LLDP
frame transmission.
lldp timer fast-interval interval The default setting is 1 second.
Setting an encapsulation format for LLDP frames
LLDP frames can be encapsulated in the following formats:
• Ethernet II—With Ethernet II encapsulation configured, an LLDP port sends LLDP frames in Ethernet
II frames.
• SNAP—With SNAP encapsulation configured, an LLDP port sends LLDP frames in SNAP frames.
LLDP of earlier versions requires the same encapsulation format on both ends to process LLDP frames. To
successfully communicate with a neighboring device running LLDP of earlier versions, the local device
must be configured with the same encapsulation format.
To set the encapsulation format for LLDP frames to SNAP:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter Layer 2/Layer 3
Ethernet interface view,
management Ethernet
interface view, or Layer
2/Layer 3 aggregate
interface view.
interface interface-type interface-number N/A
3. Set the encapsulation
format for LLDP frames to
SNAP.
• In Layer 2/Layer 3 Ethernet interface
view or management Ethernet interface
view:
lldp [ agent { nearest-customer |
nearest-nontpmr } ] encapsulation snap
• In Layer 2/Layer 3 aggregate interface
view:
lldp agent { nearest-customer |
nearest-nontpmr } encapsulation snap
By default, Ethernet II
encapsulation format
applies.