H3C Technologies H3C S5560 Series Switches - Manual (Page 79)

45
Displaying and maintaining Ethernet link
aggregation
Execute display commands in any view and reset commands in user view.
Task Command
Display information for an aggregate interface
or multiple aggregate interfaces.
display interface [ bridge-aggregation |
route-aggregation ] [ brief [ down ] ]
display interface [ { bridge-aggregation |
route-aggregation } [ interface-number ] ] [ brief
[ description ] ]
Display the local system ID. display lacp system-id
Display the global or group-specific
link-aggregation load sharing modes.
display link-aggregation load-sharing mode [ interface
[ { bridge-aggregation | route-aggregation }
interface-number ] ]
Display detailed link aggregation information
for link aggregation member ports.
display link-aggregation member-port [ interface-list ]
Display summary information about all
aggregation groups.
display link-aggregation summary
Display detailed information about the specified
aggregation groups. display link-aggregation verbose [ { bridge-aggregation |
route-aggregation } [ interface-number ] ]
Clear LACP statistics for the specified link
aggregation member ports.
reset lacp statistics [ interface interface-list ]
Clear statistics for the specified aggregate
interfaces. reset counters interface [ { bridge-aggregation |
route-aggregation } [ interface-number ] ]
Ethernet link aggregation configuration examples
Layer 2 static aggregation configuration example
Network requirements
On the network shown in Figure 12 , perform the following tasks:
• Configure a Layer 2 static aggregation group on both Device A and Device B.
• Enable VLAN 10 at one end of the aggregate link to communicate with VLAN 10 at the other end.
• Enable VLAN 20 at one end of the aggregate link to communicate with VLAN 20 at the other end.