Lldp configuration task list, Performing basic lldp configurations, Enabling lldp – H3C Technologies H3C S5560 Series Switches User Manual
Page 274
240
LLDP configuration task list
Tasks at a glance
Performing basic LLDP configurations:
•
(Required.)
•
(Optional.)
Configuring the LLDP bridge mode
•
(Optional.)
Setting the LLDP operating mode
•
(Optional.)
Setting the LLDP reinitialization delay
•
(Optional.)
•
(Optional.)
Configuring the advertisable TLVs
•
(Optional.)
Configuring the management address and its encoding format
•
(Optional.)
•
(Optional.)
Setting an encapsulation format for LLDP frames
(Optional.)
(Optional.)
Configuring LLDP trapping and LLDP-MED trapping
Performing basic LLDP configurations
Enabling LLDP
To make LLDP take effect on specific ports, you must enable LLDP both globally and on these ports.
To use LLDP together with OpenFlow, you must enable LLDP globally on OpenFlow switches. To prevent
LLDP from affecting topology discovery of OpenFlow controllers, HP recommends that you disable LLDP
on ports of OpenFlow instances. For more information about OpenFlow, see OpenFlow Configuration
Guide.
To enable LLDP:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
- H3C S5130 Series Switches H3C S5120 Series Switches H3C SR8800 H3C SR6600-X H3C SR6600 H3C MSR 5600 H3C MSR 50 H3C MSR 3600 H3C MSR 30 H3C MSR 2600 H3C MSR 20-2X[40] H3C MSR 20-1X H3C MSR 930 H3C MSR 900 H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSWM1WCM10 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module