Wavetronix Click 500 (programmable controller) (CLK-500) - Developer Guide - Manual (Page 29)

28 CHAPTER 2 • iNSTALLING THE dEVELOPMENT TOOLS
˽ Build day of month (DD) – 17
˽ Daily build number – 3
Note
If your application uses Click Supervisor, this software can be downloaded separately
at www.wavetronix.com/support.
Installing Dynamic C
Follow the steps below to download the Dynamic C software:
1 Go to www.rabbit.com/support/downloads/dc/dc10.shtml. The Click 500 example
code and applications have been tested with Dynamic C version 10.40 (it may also
work with newer versions).
2 Follow the online instructions to download the installation software package and com-
plete the installation process.
3 Run the installer program (usually named something close to “DynamicC_10.40_
WebFull.exe”).
Note
Contact Wavetronix Technical Services if you have questions on how to acquire a spe-
cific version of the Click 500 software package or the Dynamic C software.
Configuring Dynamic C
Once installed, the Dynamic C must be configured to work with the Click 500 hardware
and software. Follow the steps below to configure the Dynamic C IDE:
1 Run the Dynamic C software.
2 Select File > Project > Open from the menu bar and browse to the directory where
the Click 500 software package has been decompressed (i.e. “C:\CLICK500_
V1.0.09.07.29.01”).
3 Select the Examples.dcp project from the Examples subdirectory and click Open.