Wavetronix Click 500 (programmable controller) (CLK-500) - Developer Guide - Manual (Page 25)

24 CHAPTER 1 • USING THE CLICK 500
Voltage Threshold 1 2 3 4 5 6
22.7 VDC – – – – – ON
11.6 VDC – – – – – OFF
Table 1.4 – Voltage Supply Monitoring Circuit DIP Switch 2 Settings
Using the Menu
The hardware user interface consists of a push-button and 12 LED indicators that allow
you to access the menu and its custom operating functions. The push-button allows you to
control the state of the device, while the LEDs report status information (see Figure 1.11).
Sub Menu 1
Sub Menu 2
Main Menu
Push-button
Yellow LEDs
Red LEDs
Multicolored LEDs
Figure 1.11 – Click 500 User Interface Menu
LEDs
Table 1.5 below shows the state of the system LEDs when a mode or task is selected:
Mode/Task Red System
LED State
Blue System
LED State
Green System
LED State
Yellow System
LED State
Blue On On --- ---
Blue flash flashing On --- ---
Green On --- On ---
Green flash flashing --- On ---
Yellow Off --- --- On
Yellow flash flashing --- --- On
Table 1.5 – LED State while Mode/Task is Selected
The yellow and green system LEDs are additionally used to display data reception and
transmission. The yellow system LED will begin flashing when data is being received on any