Wavetronix Click 500 (programmable controller) (CLK-500) - Developer Guide - Manual (Page 26)

CHAPTER 1 • USING THE CLICK 500 25
of the serial ports; the green system LED will begin flashing when data is being transmitted
on any of the serial ports.
Menu
The menu is used to select and run an application’s operating functions. Select an operat-
ing function by navigating though the main menu (multicolored LEDs) and the submenus
(yellow and red LEDs).
Selecting an Operating Function
Follow the steps below to select an operating function from the menu:
1 Enter the main menu by holding the push-button down. Continue holding the push-
button to cycle through the entire menu of functions.
2 Release the push-button once the cycle reaches the desired function.
3 Press the push-button again to select the function. Once selected, the function will
either start running or the first submenu will start.
4 Hold the push-button to cycle through the first submenu.
5 Release the push-button once the desired submenu selection is displayed.
6 Press the push-button again to select the function. Once selected, the function will
either start running or the second submenu will start.
7 Hold the push-button to cycle through the second submenu.
8 Release the push-button once the desired submenu selection is displayed.
9 Press the push-button again to select the function. The function will now start running.