Sundance SMT381 2004 - Manual (Page 80)

//*************************************************//
// SMT381 Test Software - Version 1.0 //
// Basic Setup: T1: SMT365; T2: SMT391; T3: SMT321 //
//*************************************************//
MM24: SMT381 DAC setup SUB-MENU:
*************************
DAC Core Registers:
1: DAC CORE CLOCK DELAYS Register Address:0x1B2
2: DAC CONFIG Register Address:0x1C0
3: SYSTEM CLOCK DELAYS Register Address:0x1C1
4: POWER DOWN Register Address:0x1C3
5: SYSTEM MISC Register Address:0x1C4
WaveForm Memory Module Registers:
6: WMM CONFIG Register Address:0x00
7: WMM EVEN CONFIG Register Address:0x10
8: WMM EVEN MUX CTRL Register Address:0x11
9: WMM EVEN RAM CTRL Register Address:0x12
10: WMM EVEN RAM DATA Register Address:0x13
11: WMM ODD CONFIG Register Address:0x20
12: WMM ODD MUX CTRL Register Address:0x21
13: WMM ODD RAM CTRL Register Address:0x22
14: WMM ODD RAM DATA Register Address:0x23
OTHER OPTIONS:
15: Reset DAC
16: Read a register
17: Return to the Main Menu
Select:
Figure 72. SMT381 Sub-Menu.
Select option ‘15’ to reset the DAC. To enable the DAC to generate a block wave
with data from the DAC select option ‘4’ and then ‘0’ for all the following questions
until the main menu is displayed again.
To set the DAC up to generate an output using the internal waveform memory follow
the following sequence (this is based on an example in the DAC datasheet (Page
43). Reset the DAC with option ‘15’. From there follow the following sequence: