Programming mode – SOMFY SONESSE 30 RTS User Manual

Page 71

QUICK PROGRAMMING FOR EOLIS 3D WIREFREE WIND SENSOR

™

ADDING BATTERIES

Awning

Awning
Front Bar

Eolis 3D

Adding Batteries

STEP 1: Remove the sensor
housing using a small screwdriver.

STEP 2: Install 2 AAA alkaline
batteries (included). Make sure
the red light blinks. If red light
does not blink, check batteries
for correct polarity.

Red
Light

STEP 1: Press the PROGRAMMING
BUTTON on the back of the remote
until the awning jogs.

STEP 2: Press the PROGRAMMING
BUTTON on the Eolis 3D Sensor
until the awning jogs.

Pen

Programming
Button

PROGRAMMING MODE

BEFORE YOU BEGIN
Make sure the "DOWN" button on
the remote extends the awning.

Clear awning of any debris
and make sure surface of awning is clean.

Apply tape and secure mounting plate to front bar of awning.

If this is incorrect please refer to relevant
motor/receiver instructions to revearse the
direction of operation for the awning.
Failure to correct this error will cause
damage to awning by extending
it during windy conditions.