SOMFY TILT WIREFREE RTS - Manual

RTS Tilt WireFree Programming & Operation Instructions TM
New & Improved w/RTS
TM WireFree Tilt now joins the Somfy RTS motor offering.
Before you begin
Motors are shipped without limit switch settings and transmitter ID’s
Steps (1-6) must be completed to ensure proper shade programming and functionality.
Power should ONLY be connected to current shade being programmed. All other
shades should be disconnected from their respective power while programming is in progress.
While programming (step 4), shade should not be inactive for longer than 2 minutes
or motor will exit programming mode.
For Multi-Channel Transmitters (Telis 4, Decora 4)
STEP ONE
STEP TWO Initiate Programming – (for use with Telis 1 & 4, Decora 1 & 4, Modulis or Chronis Timer)
The following illustrations and instructions represent the Telis hand-held remote, and
may also be applied to the Decora wireless wall switch and Chronis Timer.
1) Connect 12V battery wand or transformer to the motor
Motor should already be installed in blind.
Connect Power to Motor
Programming Instructions are for use with Telis 1&4, Decora 1&4, Modulis or Chronis Timer
NOTE: This step cannot be performed if the transmitter has
already been programmed (memorized) to blind.
TI N B Y
my
DOWN
STOP
UP
Telis Modulis Five Channel
(with tilt wheel)
CHANNEL
SELECTOR
LED
Channel
Indicator
Telis RTS Single Channel
(Standard)
my
UP
STOP
DOWN
LED
Channel
Indicator
my
UP
STOP
DOWN
CHANNEL
SELECTOR
Telis RTS Five Channel
(Standard)
LED
Channel
Indicator
UP
STOP
DOWN
Decora WireFree Wall Switch
(Standard)
For Single Channel Transmitters (Telis 1, Decora 1, Modulis or Chronis Timer)
1) On the transmitter, press and hold the UP and DOWN buttons
simultaneously until the blind jogs (blind slats have a short
up and down tilt movement).
1) Using the channel selector, select the desired channel.
2) On the transmitter, press and hold the UP and DOWN buttons
simultaneously until the blind jogs.
my
my
C SOMFY SYSTEMS, INC. 9/08 REV.2A