SOMFY SONESSE 30 RTS - Manual (Page 50)

QUICK PROGRAMMING FOR SUNEA RTS CMO MOTOR
FACTORY MODE
DESCRIPTION
The Sunea RTS CMO has 3 main features:
1. Universal motor for Retractable Awnings and Cassette Awnings
2. Back release function at top of end limit
3. Possibility to choose the closing force.
BEFORE YOU BEGIN
For initial programming, provide power only to the motor being pro-
grammed. For awning installations, an awning hood is strongly
recommended and a drip loop should be formed to prevent water
from entering the head of the motor.
If hand-held transmitter direction is not properly programmed,
Eolis/Soliris RTS sensor will not function in the manner it was intended.
Damage to motorized window covering and injury may occur as a result.
During installation, it is mandatory to test and verify the motorized
window covering operates in accordance to the commands from
hand-held transmitter.
Installer or user must verify the following Awning Installations
Hand-Held transmitter (DOWN) command:
Awning Installations: = awning moves outward or extends.
Connect 120 V to the Sunea motor
via the proper extension cable with
Nema plug.
Connect Power to Motor
PROGRAMMING MODE
Initiate Programming
On the transmitter, press and hold both the UP and DOWN
simultaneously until the awning jogs. A jog is a brief up and down or in
and out motion. In PROGRAMMING MODE, the awning will move only
when the UP or DOWN is held (or momentary fashion).
47