SOMFY SONESSE 30 RTS User Manual

Page 65

Adding a Thermo Sunis Indoor Sensor

QUICK PROGRAMMING FOR THERMO SUNIS INDOOR WIREFREE SENSOR

During initial programming, it is recommended that power
is provided only to motorized window covering being programmed.

STEP 1: Carefully remove rear cover to expose sensor control setting panel.

Repeat steps 1-3 when multiple motorized window coverings
are required to operate from the Thermo sunis sensor.

Deleting a Thermo Sunis Indoor Sensor from Memory

STEP 1: Using a paper clip, pen or similar device, press and hold the
PROGRAMMING BUTTON (approximately 3 seconds) on a previously addressed
Thermo Sunis or Somfy transmitter. (Telis, DecoFlex, etc.). The motorized
window covering will jog to confirm PROGRAMMING MODE.

STEP 2: Using a paper clip, pen or similar device, briefly press the PROGRAMMING
BUTTON (for 1 second) located on the control setting panel of the Thermo Sunis
to be deleted (See Figure 1 pg. 66). The motorized window covering will jog to
confirm the deletion of the Thermo Sunis sensor.

Outside of
Window Glass

Front of Sunis
towards outside
of window glass

SENSOR LOCATION

WINDOW GLASS MOUNT

WINDOW SILL MOUNT

Thermo Sunis sensor MUST BE mounted indoors only and should
be free from obstructions in order to correctly sense incoming light.
Sill mounts may not be suitable for some window installations.
(Sensor should be mounted in front of all interior window coverings
(See Figure 2 pg. 67).

Step 1 should not be performed with the Thermo Sunis intended
for deletion.

STEP 2: Set the motorized window covering into PROGRAMMING MODE (Refer
to the installation instructions of the relevant RTS receiver or motor for this
procedure).

STEP 3: Slide the ON/OFF Selector Switch to the ON or position. Sun LED
Indicator will illuminate for 5 seconds then extinguish.

STEP 4: Using a paper clip, pen or similar device, briefly press the PROGRAMMING
BUTTON (for 1 second) located on the control setting panel of the Thermo Sunis.
(See Figure 1 pg. 66). The motorized window covering will jog to confirm the
addition of the Thermo Sunis sensor.