SOMFY SONESSE 30 RTS - Manual (Page 42)

STEP 1: Using a paperclip or pen, press and hold the PROGRAM BUTTON
on the previously recorded transmitter until the blind jogs.
STEP 2: Using a paperclip or pen, press and hold the PROGRAM BUTTON
on the Additional (new) transmitter until the blind jogs. Additional
(new) transmitter is now added to blind memory and can be used
to operate blind.
Adding Additional Transmitters or Assigning Channels
Assigning Specific Channels to Blind
STEP 2: Select the desired channel (1-4 or all) by momentarily pressing
the Channel Selector Button on the multi-channel transmitter.
STEP 1: Using a paperclip or pen, press and hold the PROGRAM BUTTON
on the previously addressed transmitter until the blind jogs.
To prevent unwanted Channel/Transmitter assignments, ALL
PREVIOUSLY PROGRAMMED BLINDS should be UNPLUGGED until
Programming is complete.
STEP 3: Press and hold the PROGRAM BUTTON on the multi-channel
transmitter until the blind jogs. Additional (new) channel is now added
to blinds memory and can be used to operate blind.
Completing Programming and Exiting PROGRAMMING MODE
Step 6: Using a paperclip or pen, press and hold the PROGRAM
BUTTON on the back of the transmitter until the blind jogs.
TRANSMITTER IS NOW MEMORIZED AND PROGRAMMING IS COMPLETE.
If power is disconnected from blind before this step is completed,
TRANSMITTER WILL NOT BE MEMORIZED to the programmed blind however
limits (slat positions) will remain programmed. If this occurs, go back
and repeat step on Initiating Programming, then immediately return
to STEP 6 to complete programming.
(Single Channel)
(Multi-Channel Transmitters Only)
!
!
USER MODE
™ QUICK PROGRAMMING GUIDE FOR TILT WIREFREE RTS MOTOR
39