SOMFY SONESSE 30 RTS - Manual (Page 52)

To Change the LOWER Limit:
Send the motor to its current LOWER limit position with the transmitter and let
it stop. Press and hold both the UP and DOWN buttons simultaneously
until the awning jogs, then release. Adjust to a new LOWER limit position. Press
the (STOP) button until the awning jogs, then release. Check new limit.
my
To Change the UPPER Limit: (Only For Retractable Awning)
Send the motor to its current UPPER limit position with the transmitter and let
it stop. Press the and hold both the UP and DOWN buttons simultaneously
until the awning jogs, then release. Adjust to a new UPPER limit position. Press
the (STOP) button until the awning jogs, then release. Check new limit.
my
STEP 3:
set its UPPER limit automatically and confirm Press and hold (STOP) the button again until the awning moves to
STEP 4:
the awning jogs. It will now operate in a maintained fashion. Double check
limits as a precaution. Press and hold the PROGRAM BUTTON on the back of the transmitter until
my
Adjusting the Limits
Adding a Remote/Channel or Sun and Wind Sensor: First press the
PROGRAMMING BUTTON on the back of the already programmed remote until the
awning jogs. Then press the PROGRAMMING BUTTON on the remote or sun/wind
sensor that you would like to add until the awning jogs. Check it.
Resetting All Pre-Programmed Limit Settings & Channels: You will need to
disconnect power (120V AC) for 2 seconds, reconnect for 10 seconds, disconnect
for another 2 seconds and reconnect. The motor should start to move and then
stop on its own. If this does not happen, continue to perform the disconnects
until it does. Once the motor stops moving on its own, press and hold the
PROGRAMMING BUTTON on the back of the remote until the awning jogs twice.
All transmitters and limits will be erased (motor is now in FACTORY MODE). Motor
limits will need to be reestablished. Please return back to PROGRAMMING MODE
to initiate programming process.
Adding or Deleting a Transmitter
(Single Channel, Multi Channel, or Sensor)
BACK IMPULSE Function for both Standard Retractable and Cassette Awnings
This function allows you to apply tension on the fabric when the awning
is fully extended. The motor can be adjusted up to a ½ half turn.
Advanced Features Function
!
49
QUICK PROGRAMMING FOR SUNEA RTS CMO MOTOR