SOMFY SONESSE 30 RTS - Manual (Page 60)

QUICK PROGRAMMING FOR RTS REPEATER
The Somfy RTS Repeater can be used in installations to extend the range of the
® standard Radio Technology Somfy signal. It will receive the signal from a Telis or
similar device and retransmit the signal to a RTS compatible motor or receiver.
Simply plug the receiver into any 120V AC outlet. It should be located at least
halfway between the transmitting device (Telis) and receiving device (RTS Motor).
The red LED will blink, indicating communication.
QUICK PROGRAMMING FOR UNIVERSAL RTS INTERFACE (URTSI)
Set the RTS receiver or motor into its PROGRAMMING MODE. Refer to the
installation instructions of the relevant RTS receiver or motor for this procedure.
Using the rotary switch, select the channel to be programmed. Letter A through
F stand for channels 10 through 15, 0 for 16. Briefly press the PROGRAMMING
BUTTON (1 sec. max. The window treatment will jog to indicate the channel has
been memorized.
Repeat the steps above for each channel or product to be memorized.
To test the control operation, simply press the UP, STOP or DOWN buttons on the
front of the control. The window treatment should move appropriately. The
LED will flash red to indicate the radio signal has been transmitted.
PROGRAMMING MODE
For initial programming provide, power only to the motor or control
being programmed.
!
57