SOMFY SONESSE 30 RTS - Manual (Page 59)

QUICK PROGRAMMING FOR OUTDOOR LIGHTING RECEIVER RTS
PROGRAMMING MODE
Add the First Transmitter to the Memory
STEP 1: Press the PROGRAMMING BUTTON, on the Lighting Receiver for more than
2 seconds.
STEP 2: The programming LED on the receiver will light, and the lamp will light for
2 seconds.
STEP 3: Press the PROGRAMMING BUTTON on the new transmitter to attach it to the
receiver. The programming LED on the Receiver will blink, and the lamp will
light indicating the transmitter is memorized.
Press and hold the
PROGRAMMING BUTTON of
the receiver for more than
7 seconds until the LED
blinks and the light flashes
twice. This
removes ALL
memorized
transmitters
or sensors.
Removing all transmitters from memory
Step 1: Press the PROGRAMMING BUTTON, on the Outdoor Lighting Receiver RTS
for more than 2 seconds.
Step 2: The programming LED on the receiver will illuminate, and the lamp will
light for 2 seconds.
Step 3: Press the PROGRAMMING BUTTON on the new transmitter to add it to the
receiver. The programming LED on the Receiver will blink, and the lamp will light
indicating the transmitter is memorized.
Add The First Transmitter To The Memory
Adding a New Transmitter to the Memory
STEP 1: Press the PROGRAMMING BUTTON, for more than 2 seconds, on a transmitter
that is already memorized by the Lighting Receiver.
STEP 2: The programming LED on the receiver will light, and the lamp will light for
2 seconds.
STEP 3: Press the PROGRAMMING BUTTON on the new transmitter to attach it to the
receiver. The programming LED on the receiver will blink, and the lamp will light
indicating the transmitter is memorized.
56
500 WATTS MAX.
NEUTRAL
GROUND
500W Max
Lighting Output
NEUT
HOT
HOT
HOT
NEUT
GROUND
PROGRAMMING BUTTON
PROGRAMMING LED
SEQUENTIAL CONTROL BUTTON
LAMP