SOMFY SONESSE 30 RTS - Manual (Page 67)

Step 1: Carefully remove rear cover of the Thermo Sunis sensor exposing
Control Setting Panel (See Figure 4 pg. 67).
Step 2: Slide the ON/OFF Selector Switch to the ON or position. Sun
LED Indicator will illuminate for 5 seconds and then extinguish.
Step 3: Momentarily press the MODE BUTTON. Temperature LED Indicator
will illuminate for approximately 15 seconds to indicate present threshold
setting.
Setting the (temperature) Sensitivity (threshold)
Thermo Sunis should be mounted in or near window and exposed
to incoming sunlight.
QUICK PROGRAMMING FOR THERMO SUNIS INDOOR WIREFREE SENSOR
LED Indicator light will remain illuminated for approximately 15
seconds. Should the LED indicator light extinguish prior to establishing
the temperature sensitivity (threshold) setting, simply press the MODE
BUTTON momentarily to reactivate LED light.
Step 4: Using a small screw driver or similar device, rotate the Temperature
Sensitivity Selector to the fully CLOCKWISE (+) position. Temperature LED Indicator
will remain illuminated red color (See Figure 3 pg. 67).
Step 5: Slowly rotate the Temperature Sensitivity Selector COUNTER CLOCKWISE (-)
until the LED Indicator illuminates to a green color. A green colored LED indicates
the present temperature value (threshold). At this value (threshold) the
Thermo Sunis sensor will provide the necessary RTS command as selected with the
Function Selector Switch (for details reference Function Selector Switch below).
GREEN LED: INDICATES TEMPERATURE WITHIN THRESHOLD SETTING
RED LED: INDICATES TEMPERATURE BELOW THRESHOLD SETTING
!
64