SOMFY SONESSE 30 RTS - Manual (Page 49)

QUICK PROGRAMMING GUIDE FOR LT RTS CMO MOTOR
Resetting Motor Memory and Recording New Transmitter
Step 1: Perform a dual power cut in the following sequence:
1. Power-off 2 second minimum
2. Power-on 10 seconds
3. Power-off 2 second minimum
4. Power-on
The end product moves for 5 seconds in one direction, to indicate that the double
power cut has been recorded. The motor is in PROGRAMMING MODE for 2 minutes.
Step 2: Press and hold more than 5 seconds on the PROGRAMMING BUTTON
of the PREVIOUSLY recorded RTS transmitter/channel. The end-product jogs briefly
UP or DOWN indicating that the LT RTS CMO motor memory has recorded this
new transmitter.
>5 sec.
Resetting Back to FACTORY MODE
New Transmitter !
>5 sec.
Previously Recorded Transmitter !
Back to FACTORY MODE (To completely reset the LT RTS CMO motor’s memory)
Step 1: Perform a dual power cut in the following sequence:
1. Power-off 2 second minimum
2. Power-on 5 to 15 seconds
3. Power-off 2 second minimum
4. Power-on
The end product moves for 5 seconds in one direction, to indicate that the dual
power cut has been recorded. The motor is in PROGRAMMING MODE for 2 minutes.
Step 2: Press and hold more than 5 seconds on the PROGRAMMING BUTTON of
the PREVIOUSLY recorded RTS transmitter/channel. The end-product jogs briefly
UP or DOWN indicating that the LT RTS CMO motor memory has been completely
cleared.
The motor cannot be reset if it is already in FACTORY MODE. !
Adding Additional Transmitters/Sensors
STEP 1: Using a paperclip or pen, press and hold the PROGRAM BUTTON
on the previously recorded transmitter until the awning jogs.
STEP 2: Using a paperclip or pen, press and hold the PROGRAM BUTTON
on the Additional (new) transmitter/sensor until the awning jogs.
(Single Channel)
46