SOMFY SONESSE 30 RTS - Manual (Page 62)

Sunis sensor should be mounted in or near window and
exposed to incoming light.
QUICK PROGRAMMING FOR SUNIS INDOOR WIREFREE SENSOR
Setting the Light (Sun) Sensitivity (Threshold)
STEP 1: Refer to previous “Setting the Light (Sun) Sensitivity Threshold”
instructions.
STEP 2: Sunis light sensor will send a DOWN COMMAND to the RTS receiver or
motor after 5 minutes of sensing light within the set threshold.
STEP 3: Sunis RTS light sensor will send an UP COMMAND to the RTS receiver
or motor after 30 Minutes of sensing light that HAS FALLEN BELOW THE SET
THRESHOLD.
GREEN LED: INDICATES SUN (Light) WITHIN THRESHOLD SETTING
RED LED: INDICATES SUN (LIGHT) BELOW THRESHOLD SETTING
OPERATING MODE
STEP 3: Momentarily press the MODE BUTTON. LED Indicator will illuminate for
approximately 15 seconds.
LED Indicator light will remain illuminated for approximately 15
seconds. Should the LED Indicator light extinguish prior to establishing
the light sensitivity (threshold) setting, simply press the MODE BUTTON
momentarily to reactivate LED light.
STEP 4: Using a small screw driver or similar device, rotate the Sun Sensitivity
Selector to the fully CLOCKWISE (+) position. LED Indicator light will illuminate
red (See Figure 3 pg. 62).
STEP 5: Slowly rotate the Sun Sensitivity Selector COUNTER CLOCKWISE (-) until
the LED Indicator illuminates to a green color. A green colored LED indicates the
present light value (threshold). At this value (threshold) the Sunis sensor will
provide the necessary DOWN COMMAND to the motorized window covering.
Default employs output response time delays.
STEP 1: Carefully remove rear cover of Sunis Light sensor exposing control
setting panel.
!
STEP 2: Slide the ON/OFF Selector Switch to the ON or position.
!
59