SOMFY SONESSE 30 RTS - Manual (Page 55)

Recording “MY” favorite position:
To set the (STOP) position, move the drapery to the desired intermediate
position with the OPEN/UP or CLOSE/DOWN buttons then press the
(STOP) button until the drapery jogs.
Delete the “MY” position:
To delete the my (STOP) position, move to the current my (STOP) position,
then press the (STOP) button until the drapery jogs.
my
my
my
OPEN/UP Limit Adjustment:
STEP 1: Press the OPEN/UP button, to move the drapery to the limit to be
re-adjusted.
STEP 2: Press and hold the OPEN/UP and CLOSE/DOWN buttons
simultaneously until the drapery jogs.
STEP 3: Press and hold the OPEN/UP or CLOSE/DOWN buttons to move
the drapery to the new desired position.
STEP 4: To confirm the new limit, press and hold the (STOP) button until
the drapery jogs. my
QUICK PROGRAMMING FOR GLYDEA RTS
my
52
Press briefly the OPEN/UP button to move the drapery to the
OPEN/UP end limit
STEP 1: Press and hold the and CLOSE/DOWN buttons simultaneously
until the drapery jogs. Press the CLOSE/DOWN button to re-adjust the back
release position.
STEP 2: To confirm the new back release position, press and hold the
(STOP) button until the drapery jogs. For accuracy, the positioning must be
done in one movement. If the position is not satisfactory, repeat the enitre
procedures again.
my
my
STEP 3: To erase the back release position, set it on the hard stop limit.
It is required to set a back release position on thick draperies in order
to allow proper manual operation.
!
Back Release Setting :
Setting Intermediate Preferred “My” Position:
Adjusting The Limits:
Glydea 60e RTS Only
Glydea 35 RTS Only
Glydea 60e RTS Only