Quick programming for sunea rts cmo motor – SOMFY SONESSE 30 RTS User Manual
Page 53
STEP 1: Set the awning to the lowest position.
To Activate this Function:
STEP 2: Press and hold both the (STOP) and UP buttons simultaneously
until the awning jogs. The motor is in PROGRAMMING MODE.
STEP 3: Adjust the fabric's tension using the UP or DOWN buttons.
STEP 4: Press the (STOP) button until the awning jogs. The fabric's tension
has been programmed.
my
my
This function allows the fabric tension to be released after the cassette
awning is closed.
To Activate this Function:
STEP 1: Cut the power for 2 sec, then plug back in, unless you are using the
awning in the first 4 cycles.
Set the awning to the UP or CLOSED limit position with the transmitter.
Press and hold both the (STOP) and DOWN buttons simultaneously until
the awning jogs. If the Back release function was deactivated, it
is activated. If the Back Release function was active, it is deactivated.
my
!
This function enables the closing force of the cassette awning to be increased
or decreased to 3 levels (high/medium/low). The motor is factory set at the
medium level.
To Activate this Function:
STEP 2: Cut the power for 2 sec, then plug back in, unless you are using the
awning in the first 4 cycles.
STEP 1: Bring the awning to the halfway position.
BACK RELEASE Function on Cassette Awnings Only
CLOSING FORCE Adjustment For on Cassette Awnings Only
!
STEP 3: Briefly press the (STOP) and UP buttons simultaneously, then
immediately press and hold the (STOP) and UP buttons simultaneously
until the motor jogs. The motor is only in PROGRAMMING MODE for approx.
10 seconds.
STEP 4: Adjust the closing force setting using the UP and DOWN buttons.
- to increase the closing force, press the UP button until the motor jogs up
and down.
- to decrease the closing force, press the DOWN button until the motor jogs
up and down (long jog for levels 3 and 1) (short jog for level 2).
my
my
STEP 5: Press and hold the (STOP) button until the awning jogs up and down.
The new closing force has been programmed.
my
50
QUICK PROGRAMMING FOR SUNEA RTS CMO MOTOR