SOMFY SONESSE 30 RTS - Manual (Page 68)

*Command Mode 1
Go to DOWN Limit
or Sensor Location
Go to UP Limit
Go to "my” Position
Go to UP Limit
Go to DOWN Limit
Go to "my” Position
my
my
Command Mode 2 Command Mode 3
1 2 3
After 5 Minutes
After 30 Minutes
(within threshold)
(below threshold)
= Sunlight/Temp sensor within the set “Threshold.” Thermo Sunis will
provide an RTS command after approximately 5 minutes of sensing
within the set threshold.
= Sunlight/Temp Sensor below the set “Threshold.” Thermo Sunis will
provide an RTS command after approximately 30 minutes of sensing
below the set threshold
*When selected for use with Exterior Rolling Shutter or Exterior Shade
Applications, whereby the window covering is mounted externally to the
window and Thermo Sunis sensor, the window covering will travel to
location of sensor only. It is suggested that (Mode 1) is used to command
no more than (1) window covering per sensor
STEP 1: Slide the Sun/Temp Selector Switch to the desired setting
(See Figure 3 pg. 67).
= Activation of Window Covering via Sunlight only
= Activation of Window Covering via Temperature & Sunlight
STEP 2: Adjust Sunlight and Temperature Sensitivity (threshold) (Refer to Setting
theSensor Sensitivity (threshold).
Slide the Function Selector Switch to provide the necessary RTS output commands
to the window covering.
OR
Default employs output response time delays.
QUICK PROGRAMMING FOR THERMO SUNIS INDOOR WIREFREE SENSOR
OPERATING MODE
!
!
65