SOMFY SONESSE 30 RTS - Manual (Page 40)

™ QUICK PROGRAMMING GUIDE FOR TILT WIREFREE RTS MOTOR
BEFORE YOU BEGIN
The following steps must be completed to ensure proper blind
programming and functionality. Power should ONLY be connected
Connect 12V battery wand or transformer to the
motor. Motor should already be installed in blind.
This step cannot be performed if the transmitter has already been
programmed (memorized) to blind.
On the transmitter, press and hold both the UP and DOWN simultaneously
until the blind jogs (blind slats have a short up and down tilt movement).
Using the channel selector, select the desired channel. On the transmitter, press
and hold both the UP and DOWN simultaneously until the blind jogs.
Initiate Programming
For Single Channel Transmitters
For Five Channel Transmitters
Programming Instructions are for use with all RTS transmitters
STEP 1: Press and hold the DOWN button and confirm the blind tilts down.
STEP 2: Press and hold the UP button and confirm the blind tilts up.
-If blind direction is not correct (in reverse), press and
the (STOP) on
the transmitter until the blind jogs.
Blind direction is now corrected.
Blind movement should now correspond to the direction
on
the transmitter.
hold
button
MUST BE DETERMINED BEFORE SETTING BLIND LIMITS
my
Connect Power to Motor
PROGRAMMING MODE
Check the Direction of Operation
to current blind being programmed. All other blinds should be disconnected from
their respective power while programming is in progress. While programming,
blind should not be inactive for longer than 2 minutes or motor will exit
programming mode.
FACTORY MODE
!
!
37