SOMFY SONESSE 30 RTS - Manual (Page 61)

Adding a Sunis Indoor Sensor
QUICK PROGRAMMING FOR SUNIS INDOOR WIREFREE SENSOR
STEP 1: Carefully remove rear cover to expose sensor control setting panel.
STEP 2: Slide the ON/OFF Selector Switch to the ON or position.
STEP 3: Set the motorized window covering into PROGRAMMING MODE
(Refer to the installation instructions of the relevant RTS receiver or motor
or this procedure).
STEP 4: Using a paper clip, pen or similar device, briefly press the
PROGRAMMING BUTTON (for 1 second) located on the Sunis light sensor
(See Figure 1 pg. 60). The motorized window covering will jog to
confirm the addition of the new Sunis light sensor..
Repeat steps 1-3 when multiple motors are required to operate
from the Sunis light sensor.
During initial programming, provide power only to motorized
window covering being programmed.
STEP 1:
PROGRAMMING BUTTON
addressed Sunis
Light Sensor or Somfy transmitter (Telis, DecoFlex, etc.) (See Figure 1 pg. 60).
The motorized window covering will jog to confirm PROGRAMMING MODE.
STEP 2: Using a paper clip, pen or similar device, briefly press the PROGRAMMING
BUTTON (for 1 second) located on the Sunis Light Sensor to be deleted (See Figure 1
pg. 60). The motorized window covering will jog to confirm the deletion of the
Sunis light sensor.
Using a paper clip, pen or similar device, press and hold the
(for 3 seconds) on a previously
Deleting a Sunis Indoor Sensor from Memory
Sunis light sensor MUST be free from obstructions in order to correctly
sense incoming light. Sill mount may not be suitable for some window
installations (See Figure 2 pg. 62).
Outside of
Window Glass Outside of
Window Glass
Front of Sunis
towards outside
of window glass
SENSOR LOCATION WINDOW GLASS MOUNT WINDOW SILL MOUNT
PROGRAMMING MODE
!
!
!
Step 1 should not be performed with the Sunis intended for
deletion.
!
58