SOMFY SONESSE 30 RTS - Manual (Page 41)

™ QUICK PROGRAMMING GUIDE FOR TILT WIREFREE RTS MOTOR
STEP 3: Press the (STOP) button when the blind reaches the desired UPPER
limit (slat position). If necessary, adjust the desired slat position with a brief
press of either the UP or DOWN button until position is reached.
STEP 4: Once desired UPPER limit (slat position) is reached, press and hold both
the (STOP) and DOWN buttons simultaneously until the blind begins to
tilt downward, then release.
my
my
STEP 5: Once blind stops at previously set LOWER limit (slat position), press and
hold the (STOP) button for until the slats jog. This confirms both limits
(slat positions).
my
Starting with Slats in UP Position
STEP 1: Press and hold the UP or DOWN button
on the transmitter to reach the desired UPPER
limit (slat position).
STEP 2: Once the desired UPPER limit (slat position) is reached,
press and hold both the (STOP) and DOWN buttons
simultaneously until the blind begins to tilt downward, then release.
STEP 3: Press the (STOP) button when the blind reaches the desired LOWER
limit (slat position). If necessary, adjust the desired slat position with a brief
press of either the UP or DOWN button.
my
my
STEP 4: Once desired LOWER limit (slat position) is reached, press and hold both
the (STOP) and UP simultaneously until the blind begins to tilt upward,
then release.
my
STEP 5: Once blind stops at previously set UPPER limit (slat position), press
and hold the (STOP) for button until the slats jog. This confirms both limits
(slat positions).
my
Setting Limits
STEP 2: Once the desired lower limit (slat position) is reached, press and hold both
the (STOP) and UP button simultaneously until the blind begins to tilt
upward, then release.
Starting with Slats in DOWN Position
STEP 1: Press and hold the UP or DOWN button on the transmitter to
reach the desired LOWER limit (slat position).
my
Proceed to STEP 6 to complete programming.
38