SOMFY SONESSE 30 RTS User Manual

Page 43

Deleting Specific Channels/Transmitters

STEP 2: Select the desired channel (1-4 or all) or transmitter
(single channel) to be deleted.

STEP 3: Press and hold the PROGRAM BUTTON on the transmitter until
the blind jogs. Channel or transmitter is now deleted from the blind
memory and will not operate blind.

STEP 1: Using a paperclip or pen, press and hold the
PROGRAM BUTTON on the previously addressed transmitter
until the blind jogs.

™

QUICK PROGRAMMING GUIDE FOR TILT WIREFREE RTS MOTOR

STEP 1: Press the UP or DOWN directional button on the previously
addressed transmitter until the blind slats reach a desired “MY” position,
then press the (STOP) button to stop. If necessary adjust the desired slat
position by pressing and holding either the UP or DOWN button.

Setting an Intermediate (Preferred “MY” Position)

STEP 3: Activate the blind “MY” position by pressing the (STOP) button
from ANY slat position.

STEP 2: Press and hold the (STOP) button on the transmitter until the
blind jogs. “MY” slat position is now added to memory.

Blind should be stationary prior to activating “MY” position function.
If slats are actively moving (in-motion) the (STOP) button should
be pressed twice.

Activate window covering to intermediate position, then press and
hold (STOP) for 5 seconds. Window covering will jog to confirming
deletion of “my” position.

Deleting “MY” Position

Step 1 should not be performed with the transmitter intended for deletion.