SOMFY EOLIS 3D WIREFREE RTS User Manual

Eolis 3d wirefree quick reference guide

TI N B Y

Make sure the "DOWN" button on the remote extends
the awning.

Slide the mounting plate off the 3D housing. With the
awning extended, install the mounting plate using the
preferred method suggested by the awning manufacturer.

Remove the sensor housing using a small screwdriver.

Install the batteries. Make sure the red light blinks.

Press the programming button on the back of the remote
until the awning jogs.

Bring it back out and test it again. You can use the remote
to stop the awning after 5 seconds (second test mode).

Make adjustments to the sensitivity if needed and test
it again.

STEP 1

STEP 2

STEP 3

STEP 4

STEP 5

STEP 6

STEP 7

STEP 8

STEP 9

STEP 10

STEP 11

Eolis 3D WireFree Quick Reference Guide

STEP 12

Put the sensor electronics back in the housing.

Slide the housing back on the mounting plate.

Test the sensor by pushing up and down on the awning
front bar or arm until it begins to retract. You can use the
remote to stop the awning after 5 seconds (first test mode).

Press the programming button on the 3D until the
awning jogs again.